Qnap red light flashing solution

qnap 53b blinking red light

Hi, I’ve seen a lot of your videos and I’ve noticed that you’re very prepared for NAS. I own a ts653B NAS that yesterday 12/10/2019 stopped working. Mount the latest firmware with a system of 3 hard drives in raid 5 .

Flashing red every 2 seconds

The manual says that it could be any of these:

• The drive is invalid.
• The disk volume has reached its full capacity.
• The disk volume is about to reach its full capacity.
• The system fan is not functioning.
• An error occured when accessing (read/write) the data.
• A bad sector is detected on the hard drive.
• The NAS is in degraded read-only mode (two member
drives failed in RAID 5 or RAID 6 but the data can still
be read).
• Hardware self-test error

 

If you can still use it, check weather it needs replacing a disk. Or check the logs.

If it doesn’t boot, you will need to come back to me.

 

 

 

 

 


If you like this service, please consider supporting us.
We use affiliate links on the blog allowing NAScompares information and advice service to be free of charge to you. Anything you purchase on the day you click on our links will generate a small commission which is used to run the website. Here is a link for Amazon and B&H. You can also get me a ☕ Ko-fi or old school Paypal. Thanks! To find out more about how to support this advice service check HERE   If you need to fix or configure a NAS, check Fiver   Have you thought about helping others with your knowledge? Find Instructions Here  

☕ WE LOVE COFFEE ☕

Or support us by using our affiliate links on Amazon UK and Amazon US
     

locked content ko-fi subscribe

DISCUSS with others your opinion about this subject.
ASK questions to NAS community
SHARE more details what you have found on this subject
CONTRIBUTE with your own article or review. Click HERE
IMPROVE this niche ecosystem, let us know what to change/fix on this site
EARN KO-FI Share your knowledge with others and get paid for it! Click HERE

ASK YOUR QUESTIONS HERE!