RAM upgrade for Qbap NAS TVS-682 ,TVS-882 , TVS-1282

RAM upgrade for Qbap NAS TVS-682 ,TVS-882 , TVS-1282

These are official RAM sticks for x82series NAS. I will add compatible Crucial RAM bellow.

Crucial RAM

Upgrade Memory on QNAP NAS (RAM Module Installation)

Warning:
 The following instructions should only be performed by an authorized and trained
technician.
 Strictly adhere to the instructions to install a RAM module on the NAS. Failure to do so
could result in injury to human body or death.
 Before starting, please ensure that you turn off the NAS, disconnect the power
adaptor, network cable(s), and also remove any other device/cable that is attached to
the NAS.
 Please ensure that you wear an antistatic wrist strap during the entire process to
prevent electrostatic discharge. The crocodile clip should be connected to the ground.
 When installing two memory modules, it is recommended to use the same size and
ideally use the same type/model for both slots.

Follow these steps to install an extra memory module on the NAS.

1. Loosen the screws from the rear to remove the cover (TVS-682 series: 3 screws;
TVS-882 series: 6 screws; TVS-1282 series: 7 screws.)

The above figure is shown as demonstration only.
2. Remove the case cover of the NAS

3. Unplug the cable that is connected to the motherboard, loosen the screw on the fan
module, press down the hook and then pull out the module.

4. Pull the retention clips on each side so that the module can be removed. Remove the
installed memory modules.

Note: The maximum supported memory is 32GB combined.

5. Press down the memory module to the slot and until it clips into place. Ensure the
memory module sits properly with the clips in place. Install the upgraded module in
either the blue or black slots.

6. Reinstall the fan module and reconnect the cable to the motherboard, Close the case
cover and fasten the screws. Connect the power adaptor and cables back to the NAS.
7. To check that the memory module is recognized by the NAS, power up the NAS and log
into the web interface as an administrator. Go to “System Status” > “System
Information” and check the total memory in “Hardware Information”.