RAM upgrade for tvs-h1688x and tvs-h1288x

RAM upgrade for tvs-h1688x and tvs-h1288x

 

RAM-16GDR4ECK1-UD-3200
RAM-16GDR4ECK1-UD-3200      UK   USA
DDR type: DDR4(288PIN)

Capacity: 16GB

Spec: 2G X 8

Frequency: DDR4-3200

Form(PIN): 288PIN

with ECC Supported: ECC

Power Supply: 1.2V

Dram Organization: 2048M*72

Temperature: 0℃~85℃

Environmental Regulation: Halogen Free

RAM-32GDR4ECK0-UD-3200
RAM-32GDR4ECK0-UD-3200      UK   USA
DDR type: DDR4(288PIN)

Capacity: 32GB

Spec: 2G X 8

Frequency: DDR4-3200

Form(PIN): 288PIN

with ECC Supported: ECC

Power Supply: 1.2V

Dram Organization: 4G*72

Temperature: 0℃~85℃

Environmental Regulation: RoHS

RAM-8GDR4ECI0-UD-3200
RAM-8GDR4ECI0-UD-3200      UK   USA
DDR type: DDR4(288PIN)

Capacity: 8GB

Spec: 512M X 8

Frequency: DDR4-3200

Form(PIN): 288PIN

with ECC Supported: ECC

Power Supply: 1.2V

Dram Organization: 1024M*72

Temperature: 0℃~85℃

Environmental Regulation: RoHS

Alternative options:

A-Tech 8GB DDR4 3200MHz DIMM PC4-25600 UDIMM Non-ECC CL22 1.2V 288-Pin Desktop Computer RAM Memory Upgrade Module

UK   USA

1. Power off the device.
2. Disconnect the power cord from the electrical outlet.
3. Disconnect all cables and external attachments.
4. Remove the case cover.
a. Loosen the screws.
b. Slide the cover back.
c. Lift the cover off the device

5. Place the device on its left side.
6. Remove the fan module.
a. Disconnect the fan module from the right panel.

b. Remove the screw that secures the fan module to the chassis.
c. Press the clip and then pull the fan module away from the right panel.

7. Optional: Remove an existing module.
a. Push the retention clips outward simultaneously to release the module.
b. Verify that the module has tilted upward and is completely released from the slot.

c. Hold the module by the edges.

d. Carefully slide the module out of the slot.

8. Install a new module.
a. Align the notch with the ridge in the slot.
b. Insert the module into the slot.
c. Verify that the metal connectors are completely inserted into the slot.
d. Carefully press down on the module until the retention clips lock the module into place.

9. Attach the fan module.
a. Align the protruding part of the fan module with the hole on the chassis below the M.2 SSD slot.
b. Push the fan module toward the system board until the clip locks the fan module into place.
c. Attach the screw that secures the fan module to the chassis.

 

d. Connect the fan cable to the right panel

10. Place the device in its normal upright position.
11. Attach the case cover.
a. Place the cover on the device.
b. Slide the cover forward.
c. Tighten the screws.

 

 

Posted in Uncategorized

DISCUSS with others your opinion about this subject.
ASK questions to NAS community
SHARE more details what you have found on this subject
CONTRIBUTE with your own article or review
IMPROVE this niche ecosystem, let us know what to change/fix on this site

ASK YOUR QUESTIONS HERE!